Terminal

A terminal is a part from the element that will allow a connection with one conductor during the schema creation.

Create terminal

The terminal can only be added to workspace from toolbar.

  1. Select the icon icon_terminal from toolbar to add a terminal.

  2. Click on the initial point from the terminal in the workspace to add the terminal.

Note

If the toolbar is not displayed, it can be displayed from Settings > Display > Parts.

Terminal properties

Element part proterties can be displayed from information panel when the part is selected.

Note

If the information panel is not displayed, it can be displayed from Settings > Display > Information.

../../../_images/qet_element_part_terminal.png

Figure: QElectroTech terminal part from element

QElectroTech allows customizing different terminal properties:

Position:

The start point coordinates (x, y) can be defined.

Orientation:

The exit direction from the connector can be defined. The four possible orientations are North, East, South and West.

Name:

Terminal uuid.