Cut part

QElectroTech element editor allows cutting the different possible type of parts to paste them later on at different place from the element editor workspace.

Note

Multiples parts can be cut at the same time, pressing Ctrl is necessary to select more than one part.

Cutting parts can be done from menu bar, by right click on the part and from the corresponding keyboard shortcut.

Cut part from menu bar

1. Select the part which should be cut.

2. Select Edit > Cut menu item to cut the part.

Figure: QElectroTech Edit menu

Cut part by right click

1. Right click on the part which should be cut.

2. Select the option Cut to cut the part.

Figure: QElectroTech right click PopUp window

Cut part using keyboard shortcut

QElectroTech allows using keyboard shortcut to increase the working efficiency.

1. Select the part which should be cut.

2. Press Ctrl + x to cut the part.

See also

For more information about QElectroTech keyboard shortcut, refer to menu bar section.